BGP
Nodegrid SR OOB Network performance
Introduction: The Nodegrid can be used as the gateway to the OOB network OOB-LAN to segregate from the production network. In doing so, it is necessary to know the performance of the OOB-LAN to validate if the network is adequate for all the devices ...
Palo Alto internal VM with Network segmentation
Introduction: Setting up the Palo Alto VM internal to the Nodegrid to segment the traffics from different virtual networks. The public IP is passthrough to the internal PA and allows access to all internal Networks that are configured behind the ...
FRR Routing Protocol Suite
FRR Routing On Nodegrid Service Router FRRouting(FRR) is an IP routing protocol suite for Linux and Unix platforms which includes protocol daemons for BGP, IS-IS, LDP, OSPF, PIM, and RIP. NG has the network tool vtysh(quagga/FRR) to administer the ...
Supported USB LTE Modems
Currently Supported USB LTE Modems: Verizon USB620L Verizon USB730L (Support only on 4.2.7 and above)
NodeGrid Multi-routing
NodeGrid supports IP multi-routing and allows to set default gateway per interfaces. The unit enforces that data traffic is sent through the same network interface the package was received. In other words, packages received from ETH0 network will be ...
USB Modems Validated by ZPE Systems
Even though NodeGrid has support for a wide range of wireless modems, these are the models we validated so far: Verizon USB Modem U620L AT&T Beam USB Modem Sierra Wireless AirLink ES450 (carrier: Verizon)
How to Enable Network Bonding on the Nodegrid Serial Console
Below are the steps to configure network bonding with ETH0 and ETH1. WebUI Open a browser, enter the Nodegrid Serial Console IP/hostname, and log in as admin Go to Network :: Connections page Click on Add, and fill out the form as follows: Enter a ...
How to Configure Network Bridge on the Nodegrid Serial Console
Nodegrid Serial Console cascades, or daisy chains, network ports by implementing a network bridge between ports ETH0 and ETH1. In this configuration several NSC units can be used in cascade mode, all sharing the same network switch port, saving a ...
Network Configuration via CLI
Example of configuring the ETH0 interface via CLI (please, replace the network values with your own information). Log in as admin to the Nodegrid console port or HDMI Type the following commands (in bold): [admin@nodegrid /]# cd ...
LLDP Settings
Nodegrid supports LLDP on its network interfaces. The Nodegrid advertises its identity and capabilities information on the LAN, as well as receiving same information from other devices with this feature enabled. To enable LLDP on the NodeGrid, follow ...